Jeep Grandee Cheroki
+ Jeep Grand Cherokee brand Cars
+ Settings and routine maintenance
+ Ryadny six-cylinder engine
+ V8 Engine
+ Procedures of the general and major maintenance of the engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
- Coupling and transmission line
General information
Coupling - the general description and check of serviceability of functioning
Removal and installation of components of hydraulic system of switching off of coupling
Removal, check of a condition and installation of components of coupling
Removal, check of a condition and installation of the vyzhimny bearing of coupling
Check of a condition and replacement of the directing bearing
Driveshafts, differentials and bridges - the general information
Check of a condition of the transmission line
Removal and installation of driveshafts
Replacement of kardanny hinges
Replacement of an epiploon of a shaft of a leading gear wheel of differential
Removal, service and installation of a nave and bearings (forward wheel)
Removal, major maintenance and installation of a forward power shaft
Removal and installation of assembly of the forward bridge
Removal and installation of a back semi-axis and bearing assembly
Removal and installation of assembly of the back bridge
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and operation receptions
|
Removal and installation of components of hydraulic system of switching off of coupling
Components of assemblies of the main and executive cylinders of coupling
|
|
The hydraulic system of switching off of coupling is served as uniform assembly. If in system there are leaks or in it air gets, to replace it also follows the uniform block. |
|
|
- To Poddomkratta the car also establish it on props.
- Give nuts of fastening of the executive cylinder to the coupling case.
- Liberate the hydraulic line of coupling from fixing clips on the case.
- Lower the car on the earth.
- Remove a ring of the holder, the flat and goffered washers, fixing a pusher of the main cylinder to a coupling pedal.
|
|
Details of knot of joining of a pusher with a coupling pedal.
|
- Disunite the electric socket of wires of the sensor switch of provision of a pedal of coupling, then remove a rod of a pusher of the main cylinder from a finger of fastening it to a pedal. Check a condition of plugs of a finger. Replace worn-out components.
- In order to avoid a spillage of liquid make sure that the cover of the tank of the main cylinder is densely closed, then give screws of fastening of the tank and a nut of hairpins of fastening of the cylinder to a partition of an impellent compartment.
- Remove all assembly. Do not try to disconnect the hydraulic line from the main or executive cylinders.
- Installation make upside-down. All fixture tighten with demanded effort.
|
|
|
|
