Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grandee Cheroki
+ Jeep Grand Cherokee brand Cars
+ Settings and routine maintenance
+ Ryadny six-cylinder engine
+ V8 Engine
+ Procedures of the general and major maintenance of the engine
+ Systems of cooling, heating and air conditioning
- Power supply system and production of the fulfilled gases
   General information
   Procedure of dumping of pressure of fuel
   Check of pressure of fuel and functioning of the fuel pump
   Removal and installation of a fuel tank
   Cleaning and repair of a fuel tank - the general information
   Repair and replacement of fuel lines
   Removal and installation of the fuel pump
   Check of serviceability and replacement of the block of the fuel level sensor
   Removal and installation of assembly of an air purifier
   Replacement of a cable of gas
   System of injection of fuel - the general information
   Check of serviceability of system of injection of fuel
   Serviceability check, removal and installation of the case of a throttle
   Check of serviceability and replacement of a regulator of pressure of fuel
   Serviceability check, removal and installation of injectors of fuel
   Check of functioning and replacement of components of system of stabilization of turns of idling (IAC)
   Service of system of production of the fulfilled gases - the general information
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and operation receptions
0ea6cc78 0ea6cc78



General information

Models of cars described in this Management are equipped with system of consecutive multipoint injection of fuel (MPFI). The system uses clock pulses for ensuring consecutive injection of fuel directly to the inlet port of each of cylinders. Work of injectors is supervised by the power module of management (RSM). RSM traces various parameters of the engine and on the basis of the analysis of received information defines exact amount of fuel which should be injected at present in a certain sequence into inlet ports of the engine.

All models are equipped with the electric fuel pump established in a fuel tank. For ensuring access to the aforementioned pump the fuel tank is necessary for removing. The fuel level sensor is built in directly the fuel pump and is taken from a tank similarly.

The system of production of the fulfilled gases consists of a final collector (ов), the catalytic converter, exhaust pipes and the exhaust silencer. Each of the listed components can be replaced in an individual order. More detailed information on the catalytic converter is presented in the Head of System of decrease in toxicity of the fulfilled gases and engine management.