Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grandee Cheroki
+ Jeep Grand Cherokee brand Cars
+ Settings and routine maintenance
- Ryadny six-cylinder engine
   General information
   The repair procedures, which performance it is possible without engine extraction from the car
   Reduction in the provision VMT of a step of compression of the piston of the first cylinder
   Removal and installation of a cover of a head of cylinders
   Removal, check of a condition and installation of yokes and bars of pushers
   Replacement of klapanny springs, their plates and maslootrazhatelny caps
   Removal and installation of the inlet pipeline / final collector
   Removal and installation of a head of cylinders
   Replacement of a forward epiploon of a cranked shaft
   Condition check, removal and installation of a cover of a distributive chain, chain and its asterisks
   Removal, check of a condition and installation of a camshaft, bearings and hydraulic pushers
   Removal and installation of the pallet of a case
   Removal, check of a condition and installation of the oil pump
   Removal and flywheel installation / driving disk
   Replacement of a back epiploon of the crankshaft
   Check of a condition and replacement of rubber pillows of support of the engine
+ V8 Engine
+ Procedures of the general and major maintenance of the engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and operation receptions


0ea6cc78 0ea6cc78

Removal and installation of a cover of a head of cylinders

 PERFORMANCE ORDER

  1. Remove from a cover of a head of cylinders a hose of CCV both a hose and a tube of ventilation of a case.

Location of hoses of CCV and ventilation of a case (shooter).

  1. Remove clips of a plait of wires, remembering the provision of their hairpins for the correct installation at assembly.
  2. Liberate from clips on the top part of a cover of a head of cylinders cables of gas, a butterfly valve drive in a mode kik-Down and control systems of speed (tempostaty). Disconnect cables from the case of a throttle and put them aside.
  1. Disconnect from the throttle case cables of gas, a butterfly valve drive in a mode kik-Down and темпостата, liberate cables from clips on a cover of a head of cylinders and put them aside.
  1. Give fixing bolts and uncover heads of cylinders. If the cover "became attached", is accurate обстучите it on perimeter a hammer with soft the brisk. Do not try to hook at all a cover the lever got under an interfaced surface of a flange!
  2. Smooth out interfaced surfaces, having carefully removed from them all traces of oil, having wiped the rags moistened in acetone.

Such covers are equipped with the reusable laying formed of stiffened RTV hermetic and fastening directly to the cover.

  1. Existence in such laying of small cracks is admissible and is eliminated with a way of greasing of the damaged site RTV hermetic before cover installation into place.
  2. Establish a cover and screw bolts. Tighten bolts with demanded effort.
  3. Establish ventilating hoses and the servo-driver темпостата (if it is provided).
  4. Start the engine and check it on leaks.