Check of a condition and repair of a heater of glass of a door of a back
The heater of glass of a door of a back represents a series of the horizontal elements pasted on a surface of glass from its inside.
Small ruptures of elements can be eliminated without glass removal.
Check
|
- Include ignition and a heater of glass of a door of a back.
- Earth a negative wire of the voltmeter on the plug A, positive connect to the plug B.
|
Verifying points of a heater of glass of a door of a back.
|
- Indications of the voltmeter should lie in limits between 10 and 15 Century. Smaller value of tension speaks about violation of quality of grounding.
- Connect a negative wire of the voltmeter to well earthed point - the indication should not change.
- Connect a negative wire to the plug A, then serially touch shchupy a positive wire an average point of each of lines of a lattice of a heater.
- Instrument reading should make each time about 6 Century. The zero indication of the voltmeter testifies to break existence between an average point With and the plug B.
- The indication in 10-14 In indicates break existence between an average point With and A.Perevedite's plug щуп towards break; after crossing of the last the indication will change.
|
|
Repair
|
- For restoration of the torn-off elements of a lattice it is recommended to use special repair sets of the MOPAR No. 4267922 type (or its equivalent). The set contains a tokoprovodny plastic epoksidny compound.
- Before the beginning of restoration of an element switch off a heater let's to it cool down within several minutes.
- Slightly rub the damaged site with thin rigid wool, then wipe it alcohol.
- Paste an insulating tape from both parties from the damaged site parallel to the element line.
|
- For restoration of the damaged site of a horizontal element of a lattice of a heater paste from both parties on a strip of an insulating tape.
|
- Carefully mix a compound according to the instructions attached to a set.
- Put a compound in a gleam between insulating tape strips on the damaged site of an element, having blocked its healthy edges approximately on 20 mm.
- Let's to a compound rise within 24 hours, then it is possible to remove an insulating tape and to test a heater.
|
|
|