Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grandee Cheroki
+ Jeep Grand Cherokee brand Cars
+ Settings and routine maintenance
+ Ryadny six-cylinder engine
+ V8 Engine
+ Procedures of the general and major maintenance of the engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
- Body
   General information
   Care of a body
   Care of the panels of furnish made of vinyl
   Care of an upholstery and salon rugs
   Repair of insignificant damages of body panels
   Repair of considerable damages of a body
   Service of loops and locks
   Replacement wind and motionless glasses
   Removal, installation and adjustment of provision of a cowl
   Removal and installation of the lock of a cowl and cable of its drive
   Removal and installation to the place of the panel of a decorative front grille
   Removal and installation of a forward wing
   Removal and installation of bumpers
   Removal and installation of the panel of an internal upholstery of a door
   Removal, installation and adjustment of provision of a door
   Removal and installation of handles, cylinder and clamp (latch) of the lock of a door
   Removal and installation of a windowpane of a door
   Removal and installation of a regulator of a window of a door
   Removal and installation of the central console
   Removal and installation of the panel of an upholstery of a door of a back
   Removal, installation and adjustment of provision of a door of a back
   Replacement of an emphasis of a door of a back
   Removal and installation of facing of a combination of devices
   Removal and installation of facings of a control panel
   Removal and installation of a control panel
   Removal and installation of covers of a casing of a steering column
   Removal and installation of rear-view mirrors
   Remove also installation of a lattice of a fairing
   Removal and installation of seats
   Control body sizes
+ System of onboard electric equipment
+ Governing bodies and operation receptions
0ea6cc78 0ea6cc78


Removal and installation of facing of a combination of devices

See the prevention at the beginning of the Section Removal and installation to the place of the panel of a decorative front grille.


 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Remove the central facing of a combination of devices (The section Removal and installation of facings of a control panel).
  3. Give two screws behind the top part of the central facing which serve for dashboard fastening.
  4. Having hooked, take a nozzle lattice обдува a windscreen, disconnect any available sensors and put a lattice aside.
  5. Give four screws in a sleeve обдува glasses which serve for dashboard fastening.
  1. Give sleeve screws обдува a windscreen (arrow).
  1. Open a ware box, give two screws of fastening of the dashboard, then pull the panel up, liberating it from clamps along the edges.
  2. Give three screws of fastening of facing of a combination of devices to the dashboard, remove facing.
  1. Give screws of fastening of facing of a combination to (arrow) dashboard.
  1. Installation make upside-down.