- Open a door of a back and cover the painted surface of a body over a doorway an old blanket or a special cover.
- Remove the panel of an internal upholstery, disunite electric sockets and take plaits of wires from a door.
- Lead round a marker flanges of loops of a door of a back.
- Having asked the assistant to hold a door, remove a telescopic emphasis (The section Replacement of an emphasis of a door of a back).
- Give bolts of loops and remove a back door from the car.
|
- For an otdavaniye of bolts of loops of a door of a back (arrow) the TORX type key is required.
|
- Installation make upside-down. At installation to the place of plaits of wires be careful not to cut isolation about keen edges of apertures.
- On termination of installation close a door of a back and make sure of adequacy of its arrangement in a body aperture.
- If the door needs correction of situation, weaken slightly bolts of loops, carefully close a door and отцентруйте it in an aperture (the drummer of the lock should appear on the door center). Very carefully open a door and tighten bolts.
|
|