- Give screws of fastening of the panel of an upholstery of a door of a back.
|
- Screw-driver with a crosswise sting give screws of the panel of an internal upholstery of a door of a back.
|
- Having carefully hooked the special tool (ask in shops of automobile accessories) or a shpaklevochny knife the upholstery panel, liberate its clamps. Without hurrying up, release the panel on all its perimeter.
|
- By means of the special tool take clamps of an internal upholstery from a back door.
|
- After liberation of all clamps delay the upholstery panel up, disunite electric sockets of plaits of wires and remove the panel.
- For ensuring access to inside of a door of a back carefully separate from it a plastic sound insulator.
|
- Try not to tear and not to extend a sound insulator at office it from an internal wall of a door of a back.
|
- Before installation of the panel of an upholstery into place make sure available of it all clamps (some at removal could remain latched at doors).
|
- Take from an internal wall of a door all clamps which have remained in it and transfer them on the upholstery panel.
|
|
|