Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grandee Cheroki
+ Jeep Grand Cherokee brand Cars
+ Settings and routine maintenance
+ Ryadny six-cylinder engine
+ V8 Engine
+ Procedures of the general and major maintenance of the engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
- Suspension bracket and steering
   General information
   Removal and installation of the forward stabilizer of cross-section stability and its plugs
   Removal and installation of forward shock-absorbers
   Removal and installation of a cross-section jet bar of a forward suspension bracket
   Removal and installation of levers of a forward suspension bracket
   Removal and installation of screw springs of a forward suspension bracket
   Removal and installation of rotary fists
   Replacement of spherical hinges
   Removal and installation of a bar of the back stabilizer of cross-section stability
   Removal and installation of back shock-absorbers
   Removal and installation of a cross-section jet bar of a back suspension bracket
   Removal and installation of levers of a back suspension bracket
   Removal and installation of screw springs of a back suspension bracket
   Removal and installation of a steering wheel
   Condition check, removal and installation of a steering drive
   Removal and installation of the steering mechanism
   Removal and installation of the pump of system of hydrostrengthening of a wheel
   Pumping of system of hydrostrengthening of a wheel
   Wheels and tires - the general information
   Corners of installation of forward wheels - the general information
+ Body
+ System of onboard electric equipment
+ Governing bodies and operation receptions
0ea6cc78 0ea6cc78


Removal and installation of a bar of the back stabilizer of cross-section stability

Removal

 PERFORMANCE ORDER

  1. To Poddomkratta a car back also establish it on props.
  2. Disconnect connecting links (racks) of the stabilizer from bridge arms.
  1. Components of a rack of the back stabilizer; if dismantling of racks for the purpose of check of a condition of their components was made, installation into place at assembly should be made them according to this drawing.
  1. For a detachment of a rack of a bar of the back stabilizer from an arm of a tubular sleeve of the bridge give this nut (shooter) (the left rack is shown, for right the picture is identical).
  1. To Otboltita collars of plugs of fastening of a bar of the stabilizer to frame beams also remove a bar from the car.
  1. For a detachment of a bar of the back stabilizer from beams of a frame give bolts (shooters) of collars of fixing plugs (the left - for right everything similarly is shown).
  1. Remove collars and plugs from a bar of the stabilizer and check them on existence of cracks, signs of wear and the general aging of a material. In case of need replace plugs.

Installation

 PERFORMANCE ORDER

  1. Put on plugs and collars a stabilizer bar. Lift a bar in adjusting situation, screw bolts and tighten them with demanded effort.
  2. Connect racks of a bar of the stabilizer to arms of the bridge and tighten with demanded effort fixing nuts.
  3. Clean jacks and lower the car on the earth.