Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grandee Cheroki
+ Jeep Grand Cherokee brand Cars
+ Settings and routine maintenance
+ Ryadny six-cylinder engine
+ V8 Engine
+ Procedures of the general and major maintenance of the engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
- Suspension bracket and steering
   General information
   Removal and installation of the forward stabilizer of cross-section stability and its plugs
   Removal and installation of forward shock-absorbers
   Removal and installation of a cross-section jet bar of a forward suspension bracket
   Removal and installation of levers of a forward suspension bracket
   Removal and installation of screw springs of a forward suspension bracket
   Removal and installation of rotary fists
   Replacement of spherical hinges
   Removal and installation of a bar of the back stabilizer of cross-section stability
   Removal and installation of back shock-absorbers
   Removal and installation of a cross-section jet bar of a back suspension bracket
   Removal and installation of levers of a back suspension bracket
   Removal and installation of screw springs of a back suspension bracket
   Removal and installation of a steering wheel
   Condition check, removal and installation of a steering drive
   Removal and installation of the steering mechanism
   Removal and installation of the pump of system of hydrostrengthening of a wheel
   Pumping of system of hydrostrengthening of a wheel
   Wheels and tires - the general information
   Corners of installation of forward wheels - the general information
+ Body
+ System of onboard electric equipment
+ Governing bodies and operation receptions
0ea6cc78 0ea6cc78



Removal and installation of forward shock-absorbers

Removal

 PERFORMANCE ORDER

  1. Weaken nuts of fastening of a wheel, поддомкратьте the car and establish it on props. Cock the parking brake and remove a wheel.
  2. Give to a hook of the top rod of the shock-absorber. For rod keeping from a provorachivaniye use a rozhkovy key. If the nut "became attached", impregnate it previously with getting oil. Probably, for keeping a rod it is necessary to use самоконтрящимися nippers as for a usual key лыски on it are quite small.
  1. At an otdavaniye of a nut of a rod of the shock-absorber (shooter) for rod keeping from a provorachivaniye it is necessary to use a rozhkovy key or самоконтрящимися nippers.
  1. Give bolts and nuts of fastening of the bottom support of the shock-absorber, then take the last through a wheel arch. Remove from the top part of the shock-absorber of a washer and rubber plugs through passage.
  1. The bottom end of the shock-absorber fastens to a case of the forward bridge by means of two bolts (arrow) with nuts (in a picture are not visible).

Installation

 PERFORMANCE ORDER

  1. As much as possible stretch the new shock-absorber. Establish on its rod a new washer and the new rubber plug through passage, then fill the shock-absorber in the top support.
  2. Establish the top rubber plug through passage with a washer and pull a rod up-down for a guarantee of the correct centering of plugs in a support. Strongly tighten a rod nut.
  3. Establish bolts and nuts of the bottom support and reliably tighten them.