Removal and installation of screw springs of a back suspension bracket
PERFORMANCE ORDER
Weaken nuts of forward wheels. To Poddomkratta a car front also establish it on props. Remove wheels.
Mark situation and disconnect from the holder of a crosspiece of a leading gear wheel of differential the forward driveshaft (Head Coupling and the transmission line), then tie up a shaft aside a piece of a wire.
Slowly omit bridge assembly so that screw springs were completely stretched. If for a podpiraniye of the bridge one jack is used only, ask the assistant to hold the bridge on the right at its lowering. Take a spring from under the car.
Check a spring on existence of defects and traces of corrosion which are capable to cause a premature exit it out of operation. In case of need make replacement.
Installation make upside-down. Make sure of correctness of landing of a screw spring (see an illustration). All fixture tighten with demanded effort.