Removal and installation of the main brake cylinder
This work also should not be made by strengths of the amateur mechanic. It is besides connected not with complexity of procedures of removal installation, and caused by need of carrying out adequate pumping of HCU. Manufacturers recommend to make preliminary pumping of the main cylinder on a workbench before installation on the car.
After installation will be made, the main brake cylinder and HCU ABS should be pumped over with use of the DRB II scanner (then all system should be pumped over also in manual). The scanner is very expensive device and can serve as a favorable investment only for a workshop of dealer office. If on your car there are any problems connected with refusals of the combined regulator, tow off it in a workshop of dealer office or on specialized car repair shop.
|