Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grandee Cheroki
+ Jeep Grand Cherokee brand Cars
+ Settings and routine maintenance
+ Ryadny six-cylinder engine
+ V8 Engine
+ Procedures of the general and major maintenance of the engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
- Automatic transmission
   General information
   Diagnostics of malfunctions - the general information
   Removal and installation of the lever of switching
   Check of a condition and adjustment of a cable of switching
   The description, replacement and adjustment of a cable of a drive of a butterfly valve in a mode kik-Down (TV cable)
   Serviceability check, adjustment and replacement of the sensor switch of permission of start
   Adjustment of a cable of a lay blokirator
   Check of a condition and replacement of a support of transmission
   Epiploon replacement
   Design description, removal and installation of lines and hoses of cooling of transmission
   Removal and installation of an additional cooler
   Removal and installation of automatic transmission
   Replacement of the module of management with transmission (TSM) (only for AW-4 and 42RЕ)
   Diagnostics of system of electronic control by automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and operation receptions


0ea6cc78 0ea6cc78

Check of a condition and replacement of a support of transmission

 PERFORMANCE ORDER

  1. To Poddomkratta the car also establish it on props.
  2. Under the car insert a big screw-driver or mount into space between lengthening of a case of transmission and a cross-section beam (2WD model), or a transfer case and a cross-section beam (all-wheel drive models). Try to hook transmission or a transfer case slightly. Transmission should not rise considerably a little over a support pillow
  1. For check of a condition of a support of transmission insert mount or a big screw-driver between lengthening of a case and a cross-section beam (2WD model) or between a transfer case and a cross-section beam (4WD model) and try to raise this lever transmission over its support.
  1. For replacement of a pillow of a support give bolts of fastening it to a cross-section beam and to transmission.

Components of typical assembly of a support of transmission.

  1. Slightly raise transmission or a transfer case a jack and take a support pillow. Pay attention that in a cross-section beam the openings intended for centering of a support at its installation are provided.
  2. Installation make upside-down. Track reliability of a tightening of fixture.