Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grandee Cheroki
+ Jeep Grand Cherokee brand Cars
+ Settings and routine maintenance
+ Ryadny six-cylinder engine
+ V8 Engine
+ Procedures of the general and major maintenance of the engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
- Automatic transmission
   General information
   Diagnostics of malfunctions - the general information
   Removal and installation of the lever of switching
   Check of a condition and adjustment of a cable of switching
   The description, replacement and adjustment of a cable of a drive of a butterfly valve in a mode kik-Down (TV cable)
   Serviceability check, adjustment and replacement of the sensor switch of permission of start
   Adjustment of a cable of a lay blokirator
   Check of a condition and replacement of a support of transmission
   Epiploon replacement
   Design description, removal and installation of lines and hoses of cooling of transmission
   Removal and installation of an additional cooler
   Removal and installation of automatic transmission
   Replacement of the module of management with transmission (TSM) (only for AW-4 and 42RЕ)
   Diagnostics of system of electronic control by automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and operation receptions


0ea6cc78 0ea6cc78

Adjustment of a cable of a lay blokirator

 PERFORMANCE ORDER

  1. Transfer the switching lever to the situation "R", and the ignition key - in the situation LOCK (Blocking).
  2. Give screws of fastening of facing of the lever of switching and the console (Head the Body).
  3. For release of a cable delay the clamp button.
  1. For liberation of a cable delay the clamp button.
  1. Delay a cable forward, then release it and squeeze out the clamp button down to click.
  1. Delay a cable forward, then release it and squeeze out the clamp button down to click.
  1. For check of adjustment do the following procedures:
    • Transfer the switching lever to the situation "R".
    • Check functioning of the button of release of a clamp in the handle of the lever and the cylinder of the lock of ignition. The button should be in free situation (wrung out), and the cylinder of the lock of ignition freely to rotate between the provisions OFF and LOCK.
    • Transfer the switching lever to the situation DRIVE (Movement) or REVERSE (Reverse gear) and again make sure of correctness of functioning of the cylinder of the lock of ignition. This time the cylinder should not rotate.
    • Check functioning of the lever of switching. Its conclusion from the situation "R" should be possible only when the cylinder of the lock of ignition will be turned in the situation OFF (Vykl), by RUN (Movement) or START (Start). When finding the cylinder of the lock in the provisions ACCESSORY (Parking) or LOCK (Blocking).