Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grandee Cheroki
+ Jeep Grand Cherokee brand Cars
+ Settings and routine maintenance
+ Ryadny six-cylinder engine
+ V8 Engine
+ Procedures of the general and major maintenance of the engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
- Automatic transmission
   General information
   Diagnostics of malfunctions - the general information
   Removal and installation of the lever of switching
   Check of a condition and adjustment of a cable of switching
   The description, replacement and adjustment of a cable of a drive of a butterfly valve in a mode kik-Down (TV cable)
   Serviceability check, adjustment and replacement of the sensor switch of permission of start
   Adjustment of a cable of a lay blokirator
   Check of a condition and replacement of a support of transmission
   Epiploon replacement
   Design description, removal and installation of lines and hoses of cooling of transmission
   Removal and installation of an additional cooler
   Removal and installation of automatic transmission
   Replacement of the module of management with transmission (TSM) (only for AW-4 and 42RЕ)
   Diagnostics of system of electronic control by automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and operation receptions


0ea6cc78 0ea6cc78

The description, replacement and adjustment of a cable of a drive of a butterfly valve in a mode kik-Down (TV cable)

Description

The butterfly valve from transmission copes by means of a cam on the lever of a throttle which, in turn, is given by an adjustable cable. The cable of TV is attached to the executive lever fixed on an axis of the lever of a butterfly valve. The lock button on a tip is intended for cable adjustment. The correct adjustment of a TV cable provides synchronization of the lever of a butterfly valve on transmission with the lever of an axis of a zaslonka on the throttle case so the butterfly valve lever on transmission never advances the lever on the case of a throttle and does not lag behind it.

Replacement

Components of assembly of the TV cable used on transmissions AW-4 (only models of 1993 вып.)


 PERFORMANCE ORDER

  1. Remove an air purifier (Head of the Power supply system and production of the fulfilled gases).
  2. Disconnect a cable from draft of a butterfly valve on the throttle case.
Components of assembly of a cable of the butterfly valve used on transmissions 42RЕ (models 1994 and 1995 of вып.).

For a TV cable detachment from draft of a butterfly valve on transmissions 42RН and 46RН shift forward this tip (a cable will overturn therefore the flute on its wall, usually turned to the throttle case is visible; the flute enters gearing with a pin on the butterfly valve lever).

  1. Compress fixing ears of a cable and take a cable from an arm on the engine.
  2. To Poddomkratta the car also establish it on props.

AW-4 (only models of 1993 вып.)

 PERFORMANCE ORDER

  1. Remove the pallet of a case of transmission (Head of Control and routine maintenance).
  2. Disconnect a cable from a butterfly valve cam.
  1. Disconnect a TV cable from a butterfly valve cam (only AW-4 models of 1993 вып.).
  1. Give a bolt of an arm of a cable and remove an arm together with a cable from a case.
  1. Give a bolt of an arm of a cable and remove an arm together with a cable from a case (only AW-4n models of 1993 вып.).
  1. Remove and throw out a cable sealant.
  2. Grease a new sealant and establish it on a cable.
  3. Enter a cable into a transmission case.
  4. Connect a cable to a butterfly valve cam.
  5. Establish a cable arm on a case and strongly tighten a fixing bolt.
  6. Establish into place the pallet of a case of transmission (Head of Control and routine maintenance).

42RЕ and 42RH/46RH (models 1994 and 1995 of вып.)

 PERFORMANCE ORDER

  1. Remove a cable from a hairpin on the butterfly valve lever on transmission.
  1. Disconnect a TV cable from the butterfly valve lever on transmission (transmission 46RН is shown; on transmissions 42RЕ and 42RН the picture is similar).
  1. Disconnect a cable from an arm on transmission.
  1. Liberate a TV cable from an arm on transmission (transmission 46RН is shown; on transmissions 42RЕ and 42RН the picture is similar).
  1. Establish in an arm a new cable.
  2. Fix a cable on a hairpin on the butterfly valve lever.

All models

 PERFORMANCE ORDER

  1. Clean jacks and lower the car on the earth.
  2. Fix in an arm on the engine and on draft of a butterfly valve a new cable (Head of the Power supply system and production of the fulfilled gases).
  3. Establish into place an air purifier (Head of the Power supply system and production of the fulfilled gases).
  4. Fill transmission by liquid of a demanded grade (Head of Control and routine maintenance).
  5. Make cable adjustment.

Adjustment

AW-4 (only models of 1993 вып.)

 PERFORMANCE ORDER

  1. Transfer transmission to the situation "R" and make sure that the ignition key will turn in the situation OFF. Squeeze out the button of release of a cable.
  1. Squeeze out the button of release of a cable, then push a cable cover in a case against the stop (only AW-4).
  1. Turn the butterfly valve lever on the throttle case, having completely opened a zaslonka, allow a ratchet to occupy the correct adjusting situation at lever turn, then release the lever of a butterfly valve (AW-4).

42RЕ (models 1994 and 1995 of вып.)

 PERFORMANCE ORDER

  1. Remove an air purifier (Head of the Power supply system and production of the fulfilled gases).
  2. Make sure that the lever on the case of a throttle is in the provision of pure idling (the zaslonka is closed) and that the butterfly valve lever on transmission also is in the provision of idling (will shift forward against the stop).
  3. Unhook a cable from a fixing hairpin on the lever on the throttle case (see illustrations "Components of assembly of a cable of a butterfly valve..." and "For a TV cable detachment...").
  4. Check correctness of provision of a tip of a cable on a fixing hairpin of the lever of the case of a throttle:
    • The tip of a cable and fixing hairpin should be combined (отцентрованы the friend in relation to the friend) within 1.0 mm in both directions.
    • If violation of such centering takes place, it is necessary to make cable adjustment.
  5. Connect a cable tip to a hairpin.
  6. By means of the assistant estimate coherence of movings of levers to a zaslonka on transmission and the throttle case.
    • If both levers move synchronously, passing from single situation to the provision of a half-open zaslonka, adjustment is not broken.
    • If the lever of transmission advances the lever of a throttle or lags behind it, the cable should be adjusted.
    • If the lever of the case of a throttle comes back to the provision of the closed zaslonka quicker than the transmission lever, it is necessary to adjust a cable also.
  7. Disconnect a cable tip from a fixing hairpin of the lever of a butterfly valve on the throttle case (see illustrations "Components of assembly of a cable of a butterfly valve..." and "For a TV cable detachment...").
  8. To Poddomkratta the car also establish it on props.
  9. Make sure that the butterfly valve lever on transmission is in the provision of completely closed zaslonka. Then make sure that the zaslonka lever on the case of a throttle is in the provision of pure idling (completely closed zaslonka).
  10. Wring out the button of a clamp and release a cable. For cable liberation from an adjusting head it is enough to drown the button on 1,8 mm.

Details of installation of a TV cable on the lever on the throttle case (42RЕ and 42RH/46RH models of 1994 вып.).

Details of installation of a TV cable on the lever on the throttle case (42RЕ and 46RН models of 1995 вып.).

  1. Ottsentruyte a cable tip in relation to a fixing hairpin in a range of 1.0 mm also release the clamp button (see illustrations above).
  2. Check correctness of adjustment of a cable. Make sure of synchronism of operation of levers of a zaslonka of transmission and the throttle case (see item 1-6).