Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grandee Cheroki
+ Jeep Grand Cherokee brand Cars
+ Settings and routine maintenance
+ Ryadny six-cylinder engine
+ V8 Engine
+ Procedures of the general and major maintenance of the engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
- Automatic transmission
   General information
   Diagnostics of malfunctions - the general information
   Removal and installation of the lever of switching
   Check of a condition and adjustment of a cable of switching
   The description, replacement and adjustment of a cable of a drive of a butterfly valve in a mode kik-Down (TV cable)
   Serviceability check, adjustment and replacement of the sensor switch of permission of start
   Adjustment of a cable of a lay blokirator
   Check of a condition and replacement of a support of transmission
   Epiploon replacement
   Design description, removal and installation of lines and hoses of cooling of transmission
   Removal and installation of an additional cooler
   Removal and installation of automatic transmission
   Replacement of the module of management with transmission (TSM) (only for AW-4 and 42RЕ)
   Diagnostics of system of electronic control by automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and operation receptions


0ea6cc78 0ea6cc78

Check of a condition and adjustment of a cable of switching

Check

Cock against the stop the parking brake and make attempts of short inclusions of a starter at all positions of the lever of switching. Inclusion of a starter should take place only in positions of the R and N lever. If the starter is started at any of other positions of the lever, make draft adjustment (see below). If after adjustment the starter on the former joins at distinct from "R" or «N» transmission provisions, it is necessary to make adjustment of the sensor switch of permission of start or to replace it (The section serviceability Check, adjustment and replacement of the sensor switch of permission of start).

Adjustment

 PERFORMANCE ORDER

  1. Establish the switching lever in the situation "R". To Poddomkratta the car also establish it on props.
  2. For release of a cable of switching separate a cable casing from an arm, then, for liberation of a cable release its adjusting clip.
  1. The cable of switching is connected to the lever of switching by means of the stykovochny socket of shariko-nested type; for a socket rassoyedineniye simply knock over a cable tip from a small pin on the lever by means of a screw-driver.
  1. For a cable detachment from an arm flat-nose pliers compress together lock uvulas of a casing, then delay a cable with a casing from an arm.
  1. Make sure that the switching lever on transmission is taken away against the stop back on the last clamp. Thus transmission will be in the situation "R".
  2. Make sure that the lay blokirator works, for what make attempt повращать the driveshaft. At normal functioning of a blokirator the shaft cannot be turned.
  3. Latch a casing of a cable of switching in an arm, then press down to click an adjusting clip, having fixed thereby a cable.
  4. Lower the car on the earth.
  5. At reliably cocked parking brake make sure that inclusion of a starter possibly only of provisions of transmission of "R" and «N». If draft is adjusted normally, however the starter is started in provisions distinct from "R" and «N», check serviceability of the sensor switch of permission of start (The section serviceability Check, adjustment and replacement of the sensor switch of permission of start).
  6. Check smoothness of functioning of the lock of blocking of a steering wheel.