|
Jeep Grand Cherokee1993-1999 of releaseRepair and car operation |
|
Jeep Grandee Cheroki + Jeep Grand Cherokee brand Cars + Settings and routine maintenance + Ryadny six-cylinder engine + V8 Engine + Procedures of the general and major maintenance of the engine + Systems of cooling, heating and air conditioning + the Power supply system and production of the fulfilled gases + System of electric equipment of the engine + Systems of decrease in toxicity of the fulfilled gases and engine management + Manual box of gear shifting - Automatic transmission General information Diagnostics of malfunctions - the general information Removal and installation of the lever of switching Check of a condition and adjustment of a cable of switching The description, replacement and adjustment of a cable of a drive of a butterfly valve in a mode kik-Down (TV cable) Serviceability check, adjustment and replacement of the sensor switch of permission of start Adjustment of a cable of a lay blokirator Check of a condition and replacement of a support of transmission Epiploon replacement Design description, removal and installation of lines and hoses of cooling of transmission Removal and installation of an additional cooler Removal and installation of automatic transmission Replacement of the module of management with transmission (TSM) (only for AW-4 and 42RЕ) Diagnostics of system of electronic control by automatic transmission + Transfer case + Coupling and transmission line + Brake system + Suspension bracket and steering + Body + System of onboard electric equipment + Governing bodies and operation receptions |
General information All models of brand of cars described in this Management are equipped or a five-step manual box (switching) of transfers (RKPP), or four-stage automatic transmission (AT). All information on AT contains in this Chapter. Information on RKPP can be found in the Part the Manual box of gear shifting of this Chapter. All-wheel drive models are equipped with also transfer case. Information on a transfer case is provided in the Part the Transfer case of Head. In view of complexity of a design of AT and need of use of the special equipment for performance of the majority of procedures of its service descriptions of procedures of the general diagnostics of malfunctions, routine maintenance, adjustment and removal installation are mainly included in this Chapter only. Major maintenance of transmission (if in that there is a need) should be made by specialists of dealer office or a car-care center workshop. However, performance of procedures of removal and transmission installation quite on forces to the average amateur mechanic that allows to cut down essentially expenses on metalwork works at transmission delivery in repair. Identification On cars to which this Management is devoted electronic operated AT of four various types can to be applied. Transmission of the AW-4 type is used only on models of 1993 вып. Transmissions 42RЕ, 42RН and 46RН have a similar design (but distinct from design AW-4) and are used on models since 1994 вып. And transmissions 42RЕ and 42RН are applied only complete with 6 cylinder engines whereas 46RН it is established on all models equipped with the V8 engine. If you are the owner of model of 1994 вып., the equipped 6th cylinder engine in volume of 4.0 l, on your car will establish transmission of type either 42RЕ, or 42RН. The simplest way of examination such as transmission is survey from below the pallet of its case after preliminary lifting and reliable fixing of the car. Pallets of cases of transmissions of type 42RЕ are quite superficial and have the overturned camber on the right on the bottom; pallets of transmissions 42RН are deeper also the flat-bottomed. All models since 1995 вып. are equipped with type 42RЕ transmissions. |
|