Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grandee Cheroki
- Jeep Grand Cherokee brand cars
   + Identification numbers of the car
   Acquisition of spare parts
   - Equipment of service, tool and workplace equipment
      Equipment of service
      Fixture
      Sizes of fixture
      Procedure and order of a tightening of carving connections
      Dismantling of components
      Prokladochnye of a surface
      Councils on removal of hoses
      Tool
      Workplace equipment
   + Poddomkrachivaniye and towage
   Engine start from the auxiliary power supply
   + Automobile himikaliya, oils and greasings
   + Diagnostics of malfunctions
+ Settings and routine maintenance
+ Ryadny six-cylinder engine
+ V8 Engine
+ Procedures of the general and major maintenance of the engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and operation receptions
0ea6cc78 0ea6cc78


Dismantling of components

Dismantling of all components should be carried out in such manner that at assembly each detail could be established on the former place and the correct image. Remember characteristics of appearance, in case of need make landing marking of the details which installation can be into place made ambiguously (to such elements the persistent washer equipped with a flute on a shaft) belongs, for example. The arrangement of the removed details on a pure working surface in that order in what their removal was made will be good idea. Useful there will be also a drawing up of the elementary schematic sketches or step-by-step photography of a component subject to dismantle.

At removal of fixture try to make marking of its initial situation on assembly. Often, immediate installation of fixture and washers on a former place after removal of the corresponding detail allows to avoid confusion at assembly. In the absence of such possibility, all fixture should be put in specially prepared for this purpose broken into sections and respectively marked box, or it is simple on the separate marked boxes. Such line of action appears especially useful at work with the components consisting of a set of fine details, such as the carburetor, the generator, the klapanny mechanism, the dashboard or elements of a decorative upholstery of salon.

At a detachment of electric contacts and sockets it is necessary to pay attention to marking of wires or plaits by means of an insulating tape with the put on it digital or alphabetic code.