Jeep Grand Cherokee

1993-1999 of release

Repair and car operation

Jeep Grandee Cheroki
- Jeep Grand Cherokee brand cars
   + Identification numbers of the car
   Acquisition of spare parts
   - Equipment of service, tool and workplace equipment
      Equipment of service
      Fixture
      Sizes of fixture
      Procedure and order of a tightening of carving connections
      Dismantling of components
      Prokladochnye of a surface
      Councils on removal of hoses
      Tool
      Workplace equipment
   + Poddomkrachivaniye and towage
   Engine start from the auxiliary power supply
   + Automobile himikaliya, oils and greasings
   + Diagnostics of malfunctions
+ Settings and routine maintenance
+ Ryadny six-cylinder engine
+ V8 Engine
+ Procedures of the general and major maintenance of the engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and operation receptions

Fixture

Nuts, bolts, hairpins and the screws serving for connection among themselves of two or more details are called as fixture. At work with fixture it is necessary to remember some things constantly. Practically in any fixture this or that type of kontryashchy and stopping adaptations is applied. It can be lock washers, lock-nuts, lock tags or a fixing compound for carvings. All used carving fixture should be absolutely pure and direct, with an undisturbed carving and not rounded corners of six-sided heads which the wrench is put on. It is necessary to take for a rule obligatory replacement of the damaged nuts and bolts by the new. Special самоконтрящиеся nuts with nylon or fiber inserts are not subject to a reuse, as at an otdavaniye lose the kontryashchy properties and at assembly always should be replaced with the new.

Prirzhavevshiye bolts and nuts for simplification of unscrewing and in order to avoid damage before an otdavaniye should be processed by special getting structure. Many mechanics prefer to use for this purpose turpentine which it is convenient to put from the special small canister with a long nouse. After wetting of the "become attached" fixture by getting structure before starting its otdavaniye, it is necessary to give to structure within several minutes properly to impregnate the oxidized contact layer. Strongly rusted fixture can be cut down by a chisel, is cut by a hacksaw or removed by means of special гайколома.

When cutting a head of a bolt or a hairpin oblamyvaniya on assembly, the rest of a carving part can be drilled or taken by means of the special tool. The majority of repair trucks can undertake performance of this, also as well as others (for example, restoration of the broken carving in carving openings), repair procedures.

Flat and lock washers at assembly should be established always into place in the same order and the same way, as earlier. The damaged washers always replace with the new. Between a lock washer and a soft metal surface (for example aluminum), thin sheet metal or plastic always it is necessary to establish flat washers.