Jeep Grand Cherokee

1993-1999 of release

Repair and car operation


Jeep Grandee Cheroki
- Jeep Grand Cherokee brand cars
   + Identification numbers of the car
   Acquisition of spare parts
   + Equipment of service, tool and workplace equipment
   + Poddomkrachivaniye and towage
   Engine start from the auxiliary power supply
   + Automobile himikaliya, oils and greasings
   - Diagnostics of malfunctions
      Engine
      Engine electric equipment
      Power supply system
      Cooling system
      Coupling
      Manual box of gear shifting (RKPP)
      Automatic transmission (AT)
      Transfer case
      Driveshaft
      Bridges
      Brake system
      Suspension bracket and steering
+ Settings and routine maintenance
+ Ryadny six-cylinder engine
+ V8 Engine
+ Procedures of the general and major maintenance of the engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and operation receptions

0ea6cc78 0ea6cc78

Coupling

Coupling is not switched off (a control lever of RKPP is not transferred freely to the provision of a reverse gear and back at the pedal of coupling squeezed out to a floor)

  1. Leaks in hydraulic system of coupling take place. Check a condition of the main and executive cylinders and all hydraulic lines (Head Coupling and the transmission line).
  2. Will bend or is damaged a coupling disk (Head Coupling and the transmission line).

Coupling revolves (turns of the engine raise without increase in speed of movement of the car)

  1. The disk of coupling is polluted by oil or its frictional slips are wiped. Remove coupling (Head Coupling and the transmission line) and check a condition of its components.
  2. The coupling disk was not earned extra properly. For final extra earnings of a new disk it can be demanded from 30 to 40 normal starts of the car.
  3. It is worn-out press a coupling disk/basket (Head Coupling and the transmission line).

At inclusion of coupling there is a strong vibration

  1. The coupling disk is greasy. Remove coupling (Head Coupling and the transmission line) and check a condition of its components. Eliminate all revealed leaks.
  2. Engine or check point support are worn-out or weakened their fastening. These blocks can move slightly at coupling switching off. Check a condition of support and bolts of their fastening (Head Ryadny the six-cylinder engine).
  3. Shlitsa of a nave of a conducted disk (coupling disk) are worn-out. Remove coupling (Head Coupling and the transmission line) and check a condition of its components.
  4. The disk/basket of coupling or flywheel will bend press. Remove coupling (Head Coupling and the transmission line) and check a condition of its components and a flywheel.

Squeal or roar arise at complete inclusion of coupling (the pedal is released)

The coupling bearing in the holder of the bearing on a check point is jammed vyzhimny. Remove coupling (Head Coupling and the transmission line) and check a bearing condition. Remove all agnails and teases, and grease the bearing before installation into place.

Squeal or roar arise at complete switching off of coupling (the pedal is squeezed out)

  1. The bearing (Head Coupling and the transmission line) is worn-out or damaged vyzhimny.
  2. Springs (or diaphragm petals) a press disk in a coupling basket (Head Coupling and the transmission line) are worn-out or damaged.

The pedal of coupling remains squeezed out to a floor after its otpuskaniye

  1. Draft or vyzhimny the bearing is jammed. Check a draft condition, if necessary remove coupling components.
  2. Make sure that the pedal emphasis is established the correct type.